成人做爰免费视频免费看_成人a级高清视频在线观看,成人a大片在线观看,成人a大片高清在线观看,成人av在线播放,一a一级片,一级黄 中国色 片,一级黄 色蝶 片,一级黄色 片生活片

努氏硬度測試

努氏壓痕和維氏壓痕不同，它是不對稱的。當使用努氏標尺，尤其是200gf以下時，會使硬度值的變化體現得更為明顯。

雖然如ASTM標準中的500gf提供了努氏硬度結果轉換為其它硬度標尺的硬度轉換，但通常努氏硬度測試不用于定義宏觀硬度。通常努氏試驗力不超過1000gf, 特殊情況或材料需要更高試驗力如2和5kgf時除外，期望使用這些試驗力時將得到更大的硬度變化。

努氏金剛石壓頭的長對角線長度遠大于短對角線長度，相對于維氏壓頭，努氏壓頭能更好地獲得很短距離內的硬度變化。

是否能成功地消除試樣準備過程中造成的損傷將會影響到測試的結果；當試驗力降低時，此問題將變得更為突出。

KNOOP HARDNESS TESTER

The Knoop resulting indentation is not symmetrical as Vickers indentions and will be subject to more variations of the resulting hardness values when testing to Knoop scales, especially below 200gf.

HOW DOES THE KNOOP HARDNESS TESTER WORK?

Knoop hardness is not typically being used to define bulk hardness, although at 500 gf standards like ASTM provide conversions of Knoop results to other hardness test scales. Knoop tests are not typically performed at test forces above 1000 gf although particular circumstances and or materials may need higher forces like 2 and 5 kgf. Expect larger variations in results at these loads. The Knoop diamond indenter is designed with a significant difference between the long and short Knoop diagonals, which is often better suited for determining variations of hardness over very small distances compared to the Vickers indenter.

The success of the specimen preparation procedure in removing preparation-induced damage can, and will, influence test results; this problem becomes more critical as the test force decreases.