成人做爰免费视频免费看_成人a级高清视频在线观看,成人a大片在线观看,成人a大片高清在线观看,成人av在线播放,一a一级片,一级黄 中国色 片,一级黄 色蝶 片,一级黄色 片生活片

您好, 歡迎來到化工儀器網

| 注冊| 產品展廳| 收藏該商鋪

18948178581

technology

首頁   >>   技術文章   >>   低價處理 7011-S 通道掃描卡

深圳市美佳特科技有限公司

立即詢價

您提交后,專屬客服將第一時間為您服務

低價處理 7011-S 通道掃描卡

閱讀:1420      發布時間:2020-6-19
分享:

7011-S器件文檔內容

                          7011-C, 7011-S,                                         40-channel Multiplexer Cards

                          7111-S                                                         Quad 1×10 Multiplexer Configuration

                                                                                                           The Model 7011 40-channel multiplexer has four independent banks of 1×10

                                                                                                           switching. Each channel is 2-pole. These four banks can be combined for a

                                                                                                           wide variety of switching configurations—for example, dual 1×20, or 1×10 and

                                                                                                           1×30, or one large 1×40. The 7001 main­frame can au­to­mat­i­cal­ly configure

                                                                                                           the 7011 to switch 4-pole signals by combining channel pairs. This gives you a

                                                                                                           dual 1×10 4-­pole mul­ti­plex­er or a single 1×20 4-pole multiplexer.

                                                                                                           Each of the four multiplexer outputs on this card connects to the 7001/7002

mainframes                                                                                                 analog back­plane through removable jumpers for even greater flexibility. Two                                mainframes

                                                                                                           7011 cards can be used to make a single 1×80 multiplexer with all intercard

                                                                                                           connections through the backplane. The 7011 mul­ti­plex­er outputs can also be

                                                                                                           connected to the rows of the 7012 via the backplane for row expansion.

switch                                                                                                     The Model 7111-S is a form C?version of the 7011-S. The 7111-S is a low-­voltage,                            switch

                                                                                                           quad 1×10, single-pole form C multiplexer card. The 7111-S assembly consists

                                                                                                           of a screw terminal connector card and a relay card. External test circuits are

7002                                                                                                       wired directly to the screw terminals of the connector card.                                                 7002

                       •  Quad 1×10 multiplexer for                                                        These cards automatically configure the 7001 or 7002 mainframe. Two con­n­ ec­

and                       2-, 4-, or 8-pole operation                                                      tion options are available, screw terminal for maximum flex­i­b­ il­i­ty or a single                         and

                                                                                                           96-pin quick disconnect con­nector.

7001                   •  Connects to 7001/7002                                                                                                                                                                         7001

                          backplane for easy

                          expandability                                           MULTIPLEX CONFIGURATION: Four in­de­pen­dent 1×10 2-pole multiplex banks or two ­in­de­pen­dent 1×10 4-pole multiplex banks.

with                   •  500nV, 100pA offsets                                    Ad­ja­cent banks can be connected together. Jump­ers can be removed to isolate any bank from the backplane.                           with

Us e                                                                              CONTACT CONFIGURATION: 2-pole Form A (Hi, Lo) (1-pole form C for 7111-S).                                                             Us e

                                                                                  CONNECTOR TYPE:

                       Ordering Information                                       7011-C: 96-pin male DIN connector.

                       7011-C        Quad 1×10 Multiplexer                        7011-S and 7111-S: Screw terminal, #16AWG maximum wire size, with 0.092 inch O.D. 28 conductors per card maximum.

                                                                                  #22AWG typical wire size with 0.062 inch O.D. 88 conductors per card maximum.

                                     with 96-pin                                  MAXIMUM SIGNAL LEVEL:

                                     Mass Terminated                              DC Signals: 110V DC between any two pins, 1A switched. 30VA (re­sis­tive load).

                                     Connector Board                              AC Signals: 125V rms and 175V AC peak, between any two pins, 1A switched, 60VA (resistive load).

                       7011-S               Quad 1×10 Multiplexer                        COMMON MODE VOLTAGE: 175V peak, any pin to chassis.

                                     with Screw Terminal                          CONTACT LIFE: Cold Switching: 108 closures. At Maximum Signal Levels: 105 closures.

                                     Connector Board                              CHANNEL RESISTANCE (per conductor): <1W.

                                                                                  CONTACT POTENTIAL: 7011-C: <1µV per channel contact pair      7011-S, 7111-S: <2µV per contact pair

                       7111-S               Quad 1×10 Form                                                         <3µV typical per single contact.                                         <5µV typical per single contact.

                                     C Multiplexer with                           OFFSET CURRENT: <100pA.

                                     Screw Terminal                               ACTUATION TIME: 3ms.

                                     Connector Board                              ISOLATION:                                           HI                                                                    7011-C

                                                                                  Bank: >109W, <25pF.                                       Channel 1

                                                                                  Channel to Channel: >109W, <50pF.                    LO

                                   Accessories Available                                                                    Bank A          Channels 2-9                                       J

                                                                                  Differential: Configured as 1×10:                    HI                                 HI                             HI

                       For 7011-C:                                                >109W, <100pF. Configured as 1×40:                        Channel 10                    Output               J             Backplane

                       7011-KIT-R    96-pin Female Connector Kit                  >109W, <200pF.                                       LO                                                                LO

                       7011-MTC-1    96-pin Mass Terminated Cable, Female to      Common Mode: Configured as 1×10:                                                        LO

                                     Female, 1m                                   >109W, <200pF. Configured as 1×40:

SWITCHING AND CONTROL  7011-MTC-2    96-pin Mass Terminated Cable, Female to      >109W, <600pF.                                                                       J  J

                                     Female, 2m                                   CROSSTALK (1MHz, 50W Load): Bank:         Banks B – C

                       For 7011-S and 7111-S:                                     <–40dB. Channel: <–40dB.

                       7011-ST       Extra Screw Terminal Connection Board        INSERTION LOSS (50W Source, 50W                                                      J  J

                                                                                  Load): <0.1dB below 1MHz, <3dB

                                     Services Available                           below 2MHz.

                                                                                  RELAY DRIVE CURRENT (per relay):                     HI

                       7011-C-3Y-EW  1-year factory warranty extended to 3 years  7011-C, -S: 16mA                                          Channel 1

                                     from date of shipment                        7111-S: 28mA                                         LO

                       7011-S-3Y-EW  1-year factory warranty extended to 3 years                                            Bank D          Channels 2-9                                       J

                                     from date of shipment                                                                             HI                                 HI                             HI

                       7111-S-3Y-EW  1-year factory warranty extended to 3 years                                                            Channel 10                    Output               J             Backplane

                                     from date of shipment                                                                             LO                                 LO                             LO

                       1. 888 .KEITHLEY (U.S. only)

                              

                                                                                                                      A Greater Measure of Confidence
Mouser Electronics

Authorized Distributor

Click to View Pricing, Inventory,  Delivery  &  Lifecycle  Information:

Keithley Instruments, Inc.:

7011-S  7111-S  7011-C  7011-R

會員登錄

請輸入賬號

請輸入密碼

=

請輸驗證碼

收藏該商鋪

標簽:
保存成功

(空格分隔,最多3個,單個標簽最多10個字符)

常用:

提示

您的留言已提交成功!我們將在第一時間回復您~
在線留言
主站蜘蛛池模板: 婷婷在线成人免费观看搜索| 亚洲欧美精品无码大片在线观看| 欧美色综合网站在线看| 久久久久毛片免费观看| 各类老熟女老熟妇视频在线观看| 色狼亚洲色图| 被老师肉到失禁H| 国产亚洲欧美日本一二三本道| 年轻的母亲韩国理论片| 美女扒开腿让男人桶爽久久软件| 国产深夜男女无套内射| 日本三级韩国三级欧美三级| 国产精品熟女亚洲av麻豆| 美女内射毛片在线看3D| 国产精品涩涩涩视频网站| 免费无码高潮流白浆视频| 亚洲av对国产av| 91福利免费体验区| 蜜臀AV性色A片在线观看| 国产欧洲野花视频WWW| 上课同桌把震动器夹在腿里| 麻豆AV一区二区三区久久| 亚洲天堂久久久| 永久无码日韩A片免费看麻豆精品| 狼人大香伊蕉国产WWW亚洲| 亚洲精品日韩欧美在线| 精品日韩亚洲欧美一区| 97丨九色丨国产人妻熟女| 内射后入在线观看一区| 欧美日韩亚洲一区二区三区在线观看| 国产精品激情国产精品激情| 97伦理97伦理2018最新| 国产不卡视频在线观看| gogo人体GOGO西西大尺度高清| 黄桃网站进入页面直播| 激情婷婷丁香五月色综合| 最新国产精品剧情在线SS| 欧美另类jizzhd| 欧美日韩国产另类综合| 男男孕肚PLAY高H| 国产人妻精品久久久久久很牛|